Computed tomography devices, one of the most critical elements of health technologies, require regular technical service and maintenance due to their complex structures and high sensitivity. A detailed maintenance plan must be created for the device to operate continuously and safely. In this article, we will discuss the details of the technical service maintenance plan that should be implemented for computed tomography devices.
As Anod, we aim to extend the life of the devices, increase their performance and minimize the failure rate by preparing special maintenance plans for all healthcare institutions we serve in Ankara. Because tomography devices may face wear and deformations that affect many components in long-term use.
Why Planned Maintenance?
Unplanned use of computed tomography devices brings with it serious problems such as sudden failures, image distortions and device stoppages at the patient's bedside. Such disruptions negatively affect not only the technical service period but also the diagnosis process and patient safety.
The advantages of planned maintenance:
Extension of device life
Preservation of image quality
Early detection of faults
Early determination of spare part needs
Safe use of radiation
Monthly, Quarterly and Annual Maintenance Steps
The maintenance plan recommended by Anod is divided into three main periods:
1. Monthly Maintenance
Imaging panel cleaning
Checking of internal air filters
X-ray tube warm-up time and noise analysis
Physical check of sensor and cable connections
Error check via software interface
2. Quarterly Maintenance
Detector module performance test
RF signal level measurement
Cooling system tests and fan cleaning
General check of support modules such as MSUP and MPS
Creation of software backup and system restore point
3. Annual Maintenance
X-ray tube calibration and voltage measurements
Detailed analysis of all system components (motor, sensor, panel, RFPA)
Software updates and hardware compatibility checks
Electromagnetic interference test
Device general cleaning and physical body maintenance operations
At the end of all these operations, the device performance report is prepared and delivered to the relevant technical officers. If necessary, suggested changes and spare part reinforcement are added to the service report.
Control of Supporting Parts
Computed tomography devices consist of not only the main core system; but also support modules such as X-RAY SPARE PARTS, RFPA, MSUP, MPS. It is mandatory to control these modules simultaneously for system integrity.
As Anod, we analyze in detail not only the visible parts but also all components working in the background during the maintenance process.
Conclusion
A regular and disciplined technical service maintenance plan is essential for an uninterrupted and safe imaging process in computerized tomography systems. Planned maintenance operations carried out before malfunctions occur prevent time and cost losses. As Anod, we keep your devices ready for service safely with our expert staff and detailed maintenance protocols.