In order for medical imaging devices to operate accurately, supporting modules must also function correctly and reliably. MPS devices, which are at the forefront of these supporting devices, increase the performance of MRI devices, tomography and x-ray systems by undertaking signal and detection tasks in particular. In this article, we will discuss MPS device sensor calibration and spare part supply issues.
As Anod company, we provide expert technical service and maintenance services for MPS devices as well as all auxiliary units of medical devices. In particular, the correct operation of the sensors in the device directly affects the overall operation of the system. Sensors with degraded calibration can cause incorrect data detection and incorrect diagnoses in X-ray, mammography or computerized tomography devices.
Sensor calibration is a technical adjustment process that allows the device to make accurate measurements against environmental variables. In MPS devices, this process is usually carried out with special devices in a laboratory environment. During calibration, sensor response time, signal accuracy and resistance to environmental noise are tested. After these tests, the sensor is brought into compliance with factory standards.
Uncalibrated or damaged sensors can cause problems such as:
Image signal distortion
Low resolution data detection
Diagnostic errors
Intra-system incompatibility
Therefore, it is vital that the sensors of MPS devices are checked periodically and calibrated when necessary. As Anod, we carry out this process completely.
Another important issue is the supply of spare parts. Especially in MPS systems that work integrated with devices such as x-ray, open MRI machine, RFPA and computerized tomography, it is inevitable that some parts will wear out over time. In such cases, original spare parts should be used to ensure that the device continues to operate. Otherwise, the performance of the device may decrease or become completely dysfunctional.
As Anod, we carry out our entire spare parts supply process with certified products. The parts we use are fully compatible with the device and allow the system to work smoothly again. Sensor cards, power units, connection cables and signal converters are among the most frequently replaced components.
In summary, regular sensor calibration and the use of quality spare parts are essential for the efficient operation of MPS devices. Neglecting these two elements negatively affects the performance of not only the device but also the entire system it is connected to. As Anod, we are with you at every stage with a high technical competence service approach.